DO-ALL #18® Marine

DO-ALL #18® is equally effective in hard or soft water and fresh or sea water. Agitation is the KEY to this product. Heating the water may improve performance when using pressure washers.

Placeholder Image

DO-ALL #18 Uses

DO-ALL #18 can be used for bilge, hull, deck, cabin, upholstery, hull, engine compartment, engines, and motor drives and can be diluted with either fresh or salt water. It is safe for use on surfaces that can contact water. It must be diluted to a minimum of 1:20 for aluminum and water-based painted surfaces. It will not crack or craze on plastics when used in dilution of 1:30 . Not for use on finished floors, as it will strip the wax.

 

Where to use DO-ALL #18

Cleaning Boats in the Water and Upholstery - dilute 1:20 parts water to remove contaminants, oil, grease, tar, etc. Rinse thoroughly with water.

Decks, Cabins, Motor Compartments - dilute 1:10 and spray on and allow soaking for 1-3 minutes to thoroughly saturate heavy deposits and then spray with clean water to remove residue.

Boat Hulls and Motor Drives - use full strength or 1:1 dilution on a soft bristle brush and agitate. Follow with a rinse of 1:30-60.

Engines - dilute 1:3-5 and allow soaking for 15-20 minutes on heavy soil. Follow with 1:30-60 rinse or straight water to remove all residues, depending on level of soil.

Sump Cleaning - circulate 1:8 parts water for 30 minutes, then rinse with clean water.

Bilge Cleaning - dilute 1:10 parts either fresh or salt water and agitate by roll of the boat/yacht/ship or by coarse water spray.

Pressure Washing - dilute 1:30-60 parts water.